Safety Selector Installation and Snug-Down Procedure

Proper installation of the safety selector and snug-down screws is critical to ensure safe and reliable function of your TriggerTech trigger.

Step 1: Prepare for Installation
- Ensure the firearm is completely unloaded and safe.
- Install the trigger with the rear pin only, allowing the trigger assembly to rotate slightly.

Step 2: Install the Safety Selector
- Rotate the trigger assembly slightly to create clearance for the safety selector.
- Position the safety selector halfway between SAFE and FIRE before inserting.
- Insert the safety selector into the receiver.
- Install the second trigger pin and center both pins in the receiver.

Step 3: Snug-Down Procedure
- Set the safety selector to the SAFE position.
- Using the supplied Allen key (1/16"), firmly tighten both snug-down screws located at the rear of the trigger housing.
- Tighten evenly to ensure proper alignment between the trigger and safety selector.

Step 4: Reassembly
- Reinstall and tighten the pistol grip to the lower receiver.
- Reassemble the upper and lower receiver.

Step 5: Function Check
Please refer to the FAQ titled “How do I check if I have installed my safety properly and ensure compatibility?” to verify proper function.

If you have any questions or need assistance, please don’t hesitate to contact TriggerTech support.