Your TriggerTech trigger is set near the middle of the advertised pull weight range and can be adjusted in increments. To adjust the pull weight, insert the supplied 5/64” Allen wrench into the set screw located at the bottom of your trigger. To increase pull weight, rotate the set screw clockwise. Your trigger is designed to prevent a user from adjusting the trigger to a point where it becomes unsafe. When lowering the adjustment screw it will eventually stop clicking and fall out. This will be your absolute lowest pull weight, and you can use the trigger with the adjustment screw removed. The first three clicks in from the triggers lowest pull weight do not affect the pull weight and ensure the adjustment screw is secure in the trigger housing. When increasing the pull weight, the trigger will max out at its highest pull weight.